Power Soak 33638 SILVERWARE WASHER OWNER'S MANUAL - Manual (Page 23)

23
Removing the Pre-washed Silverware
1. Turn the unit off. Use both hands to grasp the handles at the top of
the basket, lift up, shake the basket to remove excess water, and
move the basket to a dish table.
2. Immediately place the second basket into the pre-washer. Note:
Do not add silverware to the pre-wash unit unless the basket is
in place.
3. Turn the unit on to begin washing the next batch.
4. Immediately sort the silverware into cylinders or a
compartmentalized basket and run through a dish machine one
time. Note: Silverware does not need to be rinsed, and only
one pass through the dish machine is required.
5. Discard any debris left in the basket, e.g. paper or straws that may
have been missed when inserting the soiled silverware.
Replacing the Wash Water
When the water in the pre-washer becomes soil-laden and the detergent is
expired, it must be replaced. Plan to replace the water and detergent
every four hours but increase the frequency if conditions warrant.
If you have a mobile unit, roll it to a floor sink and extend the drain hose
into the floor sink.