Power Soak 33638 SILVERWARE WASHER OWNER'S MANUAL - Manual (Page 7)

7
Products Covered by this Manual
This manual covers the following Silverware Pre-washer types. Each is available in
both a Standard Capacity version and a High Capacity version.
Free-standing Stationary
These pre-washers are not portable but do not require permanent installation into
an existing dish table. They are designed with legs but do not have casters. Their
faucets and drains are permanently connected, and their electrical connections are
made with water-tight flexible conduit.
Mobile
These pre-washers are designed with legs equipped with casters to allow them to
move about the scullery. They may also be moved to bussing areas of banquet
halls or other locations where permanent installation is not practical. They are
drained into floor sinks, and they are filled from any temperature regulated potable
water supply. Lower voltage versions have built-in power cords, and higher voltage
versions require on-site wiring by a licensed electrician.
Parts and Cutlery Washer
This specialized version is designed for larger, harder to clean wares where high
load electrical service is available. The Parts and Cutlery Washer is very similar to
the High Capacity Mobile pre-washers regarding portability and connection
requirements.
Roll-under
These pre-washers are identical to the Mobile units with two exceptions: 1) The
legs are very short so they can roll under existing dish tables, 2) They are equipped
with faucets. Like the Mobile units, they are drained into floor sinks, and they are
filled through a flexible tube from any temperature regulated potable water supply.
Weld-in
These pre-washers are designed to be integrated into existing dish tables. To be
installed, an opening in the shape of the pre-washer tank must be cut into the dish
table. The tank is then welded in. Their drain connections, faucet connections, and
electrical connections are permanent.
Drop-in
Like the Weld-in version, these pre-washers are permanent additions to dish tables.
Drop-In units are identical to Weld-ins except for the method of attachment to the
dish table. The Drop-in pre-washer uses a flange and clamp arrangement to lock
itself into the dish table opening. Also like the Weld-in units, the drain connections,
faucet connections, and electrical connections are permanent.