Oven construction, Installation, Unpacking instructions – TurboChef Technologies i3 EN User Manual

Page 12: Lifting and placing the oven

Advertising
background image

4

GENERAL OvEN INFORMATION / INSTALLATION

Figure 3: Hand Grip Locations

Oven Construction

Exterior

- Two-tone stainless steel front, top, and sides
- 304 stainless steel removable grease pan
- Ergonomic door handle
- rubber seal for surface mounting
- Side handles for lifting

Interior

- 304 stainless steel interior
- Fully-insulated cook chamber
- removable rack
- Top and bottom jetplates

Installation

Install or locate this appliance only in accordance
with the instructions below.

Unpacking Instructions

1. remove oven from packaging.
2. before discarding packaging, check it

thoroughly for accessories, consumables,

and additional literature.

3. Discard packaging.
4. Check cook cavity thoroughly for accessories,

consumables, and additional literature.

5. Discard any packaging in cook cavity.

Lifting and Placing the Oven

WArNING: The i5 oven weighs

approximately 275 lb. (125 kg); the i3 oven

weighs approximately 245 lb. (111 kg). Never

lift with fewer than two people.

WArNING: Lift only by using the provided

hand grips (Figure 3, below). Never lift the

oven by the door handle.

WArNING: The oven must be properly

placed on the table or countertop at all times.

TurboChef will not recognize a fallen oven as

a warrantable claim and is not liable for any

injuries that may result.

WArNING: This oven is not intended for

built-in installation (i.e., installing the oven in

any structure that surrounds the oven by five

or more sides). be sure to provide a minimum

of 2” (51 mm) clearance for all sides and 19”

(483 mm) clearance for the top.

1. Prepare a surface that is at least 30” (762 mm)

deep and capable of supporting

- 280 lb. (127 kg) if installing an i5 oven

- 250 lb. (114 kg) if installing an i3 oven

If installing onto an oven cart, make sure the

wheels/casters are locked.

2. Position one or more persons at the front and

back of the oven.

3. Place hands into grips (see Figure 3) and lift.
4. Place the oven on the prepared surface.
5. Install the oven rack or other provided

cooking surface.

6. Plug in the oven.

NoTE: The oven is primarily serviced through its
top. Do NoT install shelving directly over the
unit. The operator will be responsible for service
charges incurred as a result of added time required
to access the top of the oven.

Advertising