Beijer Electronics QTERM®-A12 - Manual (Page 20)

Cutting Out for Panel Mount Installation
14 QTERM-A12 Terminal
5.1 Cutting Out for Panel Mount
5.1.1 Standard Version Cutout
The standard version cutout is to be used with QTERM-A12 models that have a factory-
installed front bezel.
The standard QTERM-A12 terminal can be mounted in panels from 0.8 to 10 mm thick. No
screw holes need to be drilled to install the terminal in the panel. Make a rectangular hole in
the panel using the following dimensions.
N OTE
☞
See the “QTERM-A12 Cutout and Mounting Guide” insert that was included in the box with
the QTERM-A12 for installation instructions. Printed on the back of the insert is a cutout tem-
plate that can be used to trace the cutout area onto the housing panel.
Figure 1 is a diagram of the landscape cutout. After the cutout is complete deburr any rough
edges prior to mounting the terminal
.
Landscape Portrait
Horizontal: 302.5 ± 1 mm Horizontal: 254.0 ± 1 mm
Vertical: 254.0 ± 1 mm Vertical: 302.5 ± 1 mm
Figure 1
QTERM-A12 Landscape Cutout (units: mm)