Beijer Electronics QTERM®-A12 - Manual (Page 21)

Installation Cutting Out for Panel Mount
QTERM-A12 Terminal 15
5.1.2 Modular Version Cutout
The modular version cutout is to be used with QTERM-A12 models that DO NOT have fac-
tory-installed front bezels.
The modular version of the QTERM-A12 terminal can be mounted in panels with any thick-
ness. In addition to making a cutout in the panel, the panel must be fitted with mounting studs.
Make a rectangular hole in the panel using the following dimensions.
NOTE
☞
See the “QTERM-A12 Cutout and Mounting Guide” insert that was included in the box with
the QTERM-A12 for installation instructions. Printed on the back of the insert is a cutout tem-
plate that can be used to trace the cutout area onto the housing panel.
Figure 2 is a diagram of the landscape cutout for the modular terminal. After the cutout is com-
plete deburr any rough edges prior to mounting the terminal
.
Install the recommended studs at the locations shown in Figure 2. The studs must be able to
withstand a torque of 67.8 N cm (6 lbs in).
Landscape Portrait
Horizontal: 248.0 ± 1 mm Horizontal: 187.0 ± 1 mm
Vertical: 187.0 ± 1 mm Vertical: 248.0 ± 1 mm
Figure 2
Modular QTERM-A12 Landscape Cutout (units: mm)