Aga Ranges 6-4 Series - Manual (Page 18)

1. Locate tabs on rear of splashback assembly, into the brackets on the upper rear of the
cooker. (See Fig. 9).
Push fully into place.
Fig. 9 DESN 512394
18
SPLASHBACK
Fig. 8C DESN 513716
TO ADJUST PAN SUPPORT LEVEL
1. Loosen retaining nut using 8mm socket (See Fig. 8C).
2. To prevent rocking adjust the pan support foot using 2.5mm allen key.
3. Check pan support is level with opposing pan supports.
4. Retighten retaining nut.
HANDRAIL FITTING
1. Position handrail assembly onto locating studs at each end of facia. Ensure the grub screw
at each end of the hand rail is facing downwards.
2. Push handrail assembly fully against facia and lock in place by tightening 2 grub screws
(2
1 / 2 mm). (See Fig. 6A).