Aga Ranges 6-4 Series - Manual (Page 9)

WIRING DIAGRAM 59
CAUTION: ENSURE THAT THE COOKER IS ISOLATED FROM ELECTRIC SUPPLY
The cooker can be installed with an approved flexible connection. Supply piping should not be
less than 3/8 I/D Flexiline. Connection is made to the 1/2” NPT female thread located just below
the hotplate level on the right hand side of the cooker.
The gas flexiline connector must be fitted in the shaded area dimensioned in Fig. 3. Take into
account that it must be possible to pull the cooker forward sufficiently for servicing. Ensure
flexiline hose is not trapped between cooker back panel and rear wall. Ensure hose is routed
within the shaded area and away from shielded oven vents.
NOTE: Use soapy water solution on new gas connections to ensure there are no gas leaks.
NOTE: AN EASILY ACCESSIBLE MANUAL SHUT GAS VALVE MUST BE FITTED BEFORE
THE METAL FLEX GAS LINE.
Check for gas soundness after connecting the appliance.
9
CONNECTING TO GAS
Fig. 3 DESN 512639 B