Axis Communications Video Server AXIS 241SA - Manual (Page 15)

15 AXIS 241QA/AXIS 241SA - Video and audio streams
RTP+RTSP
This method (actually RTP over UDP and RTSP over TCP) should be your first consideration
for live video, especially when it is important to always have an up-to-date video stream,
even if some images do get dropped. This can be configured as multicast or unicast.
Multicasting provides the most efficient usage of bandwidth, especially when there are
large numbers of clients viewing simultaneously. Note however, that a multicast broadcast
cannot pass a network router unless the router is configured to allow this. It is thus not
possible to multicast over the Internet, for example.
Unicasting should be used for video-on-demand broadcasting, so that there is no video
traffic on the network until a client connects and requests the stream. However, if more
and more unicast clients connect, the server will at some point become overloaded. There is
also a maximum of 20 simultaneous viewers to be considered.
RTP/RTSP
This unicast method is RTP tunneled over RTSP. This can be used to exploit the fact that it
is relatively simple to configure firewalls to allow RTSP traffic.
RTP/RTSP/HTTP or RTP/RTSP/HTTPS
These two methods can also be used to traverse firewalls. Firewalls are commonly
configured to allow the HTTP protocol, thus allowing RTP to be tunneled.
Other methods of accessing the video stream
Video/images from the AXIS 241QA/AXIS 241SA can also be accessed in the following
ways:
• If supported by the client, the AXIS 241QA/AXIS 241SA can use Motion JPEG
server push to display video. This option maintains an open HTTP connection to
the web browser and sends data as and when required, for as long as required.
• As single JPEG images in a browser. Enter the path:
http://<ip>/axis-cgi/jpg/image.cgi?resolution=CIF
• Windows Media Player. This requires AMC and the MPEG-4 decoder to be
installed. The paths that can be used are listed below, in the order of preference.
• Unicast via RTP: axrtpu://<ip>/mpeg4/#/media.amp
• Unicast via RTSP: axrtsp://<ip>/mpeg4/#/media.amp
• Unicast via RTSP, tunneled via HTTP: axrtsphttp://<ip>/mpeg4/#/media.amp
• Unicast via RTSP, tunneled via HTTPS: axrtsphttps://<ip>/mpeg4/#/media.amp
• Multicast: axrtpm://<ip>/mpeg4/#/media.amp
Notes: • <ip> = IP address.
• # = video source number or the quad stream. This is set to 1 if omitted.