A&D TM-2430-13 - Manual (Page 37)

36
Step 13 Select the Interval drop-down menu for Period Three (3) and set the measurement
Interval for Period Three (3) to: OFF, 1, 3, 5, 10, 15, 20 , 30, 60 or 120 minutes.
Step 14 If you want to program a fourth period, go to step 15.
If you do not want to program a fourth period, go to step 17.
Step 15 Select the Time field for Period Four (4) and enter the time you want for this period;
the end period for Period Four (4) will be the Time for Period (1). Use military time to
set the Time. See examples at the end of this section.
Step 16 Select the Interval drop-down menu for Period Four (4) and set the measurement
Interval for Period Four (4) to: OFF, 1, 3, 5, 10, 15, 20, 30, 60 or 120 minutes.
Step 17 If the intervals are set correctly, click the OK button to confirm the programming. If
they are not correct, reset them, or go to step 18.
Step 18 To cancel the programming and close the Recorder–Setup dialog box, click the Cancel button.
2-7-3-2 TM-2430 Series Setup
The recorder setup for the TM-2430 series is similar to the TM-2420/TM-2421 except that it includes
two additional options for setting the BP measurement intervals as shown in Figure 22.
Figure 22: TM-2430 series Recorder-Setup dialog box
Description of each mode is as follows:
Mode 1 07:00-21:59 The measurement is performed every 15 minutes.
22:00-06:59 The measurement is performed every 30 minutes.
Mode 2 The AUTO ON/OFF key is pressed at rising and going to bed so that the measurement
intervals are changed and the time during sleep can be distinguished on the data.
When the “S” is off, the measurement is performed every 15 minutes.
When the “S” is displayed, the measurement is performed every 30 minutes.
Mode 3 The measurement interval can be changed six times within a maximum of 24 hours. (The
monitor can store six measurement intervals (periods) in 24 hours. A period consists of a
start time and interval.)