Muxlab 8 x 8 Cat 5e/6 Line Level Audio Matrix Switch - Manual (Page 31)

© MuxLab Inc. Audio 8x8 Matrix Switch Installation Guide
Page 31
Serial/USB Port Commands
1. Alarm
alarm
Description: Display all the alarm settings
Arguments: <none>
Example: alarm
2. Connection
connect -i <input port #> -o <output port #>
Description: Connect a specific input to a specific output
Arguments: <input port #>: 1 to 4
<output port #>: 1 to 4
Example: Connect input 2 to output 4
connect -i 2 -o 4
Response: [0,0,0,2]
(or an error message if the command failed)
connect -i <input port #> -o all
Description: Connect a specific input to all outputs
Arguments: <input port #>: 1 to 4
Example: Connect input 2 to all outputs
connect -i 2 -o all
Response: [2,2,2,2]
(or an error message if the command failed)
connect -i <input port #> -o <from output port #> .. <to output port #>
Description: Connect a specific input to a consecutive range of outputs
Arguments: <input port #>: 1 to 4
<from output port #>: 1 to 4
<to output port #>: 1 to 4
<from output port #> shall be inferior or equal to <to output port #>
Example: Connect input 2 to outputs 1, 2, and 3
connect -i 2 -o 1..3
Response: [2,2,2,0]
(or an error message if the command failed)
connect -json “[<input port #1>,<input port #2>,…, <output port #4>]”
Description: Make 4 connections/disconnections in one command using json format
Arguments: <input port #>: 1 to 4 to specify the input port to connect to, or 0 to disconnect it
Example: Connect input 2 to outputs 1, 2, and connect input 3 to outputs 4 , and disconnect all other
outputs.
connect -json “[2,2,0,3]”
Response: [2,2,0,3]
(or an error message if the command failed)