Figure 11: ping device status – Kramer Electronics VP-725N User Manual
Page 11
Installing and Running DeviceInstaller™
9
3. Click Ping. The results will be displayed in the Status window. Click Clear
Status to clear the window so you can ping the device again.
Figure 11: Ping Device Status
4. Click Close to close the dialog box and return to the main window.
Note
: If you do not receive “Reply” messages, make sure the unit is
properly attached to the network and that the IP address assigned is
valid for the particular network segment you are working with. If you are
not sure, check with your systems administrator.
2.4
Configuring the Ethernet Port
Using DeviceInstaller™
You must configure the Ethernet port so that it can communicate on a network with
your serial device. For example, you must set the way the unit responds to serial
and network traffic, how it handles serial packets, and when to start or close a
connection. You can configure your unit locally or remotely using the following
procedures:
Use the DeviceInstaller™ to configure the unit. Some features are only
available through the DeviceInstaller™ Installer menus
Use a standard Web browser to access the unit’s internal Web pages and
configure the unit over the network (see
Section
). This is the easiest and
preferred method
i