Kramer Electronics VP-725N - Manual (Page 23)

Installing and Configuring Com Port Redirector Software 21

Serial settings on the Kramer device must match the settings of the serial
device.
Serial settings include:
 Baud rate
 Parity
 Stop bits
 Flow control
 Interface mode (RS-232 or RS-422/485)
Consult your device server documentation for information about
configuring these serial settings for your device server

Connect/Disconnect and Access Modes
—You must configure the way
the device server accepts a connection appropriately for the device
server to accept a network connection from Com Port Redirector
 Serial cabling between the managed serial device and the device
server must be correct.
Consult your documentation for the pinouts of your device server
For specific instructions, refer to your Kramer device user manual (see the
“Controlling via Ethernet” section), the latest version of which can be downloaded
from our Web site at http://www.kramerelectronics.com .
To configure the Com Port Redirector:
1. From your Windows desktop click Start > All Programs > Lantronix >
CPR.
The Lantronix Com Port Redirector program starts and the main window is
displayed.