Kramer Electronics VP-725N - Manual (Page 6)

4 Installing and Running DeviceInstaller™
2 Installing and
Running DeviceInstaller™
To configure your Kramer machine via the Ethernet, install the DeviceInst aller™
configuration software and configure your Ethernet port, and then install the COM
Port Redirector to control the Kramer machine.
To configure the Ethernet port you must install and run the DeviceInstaller™
configuration software.
It is important to consider the following points before logging into and configuring
the Ethernet port:

The Kramer machine IP address must be configured before a network
connection is available (if you encounter problems, see Section
‎1.1
)

Only one person at a time may be logged into the network port. This
eliminates the possibility of several people simultaneously attempting to
configure the device server

Network port logins can be disabled. The system manager will not be able to
access the unit. This port can also be password protected
2.1 Installing
DeviceInstaller™
To install the DeviceInstaller™ Installer, do the following:
1. Insert the product CD into your CD-ROM drive.
2. Run the DeviceInstaller™ installer setup.
3. Respond to the installation wizard prompts.
4. Restart your system.
2.2 Running DeviceInstaller
™
Click Start on the Task Bar and select Programs\Lantronix\DeviceInstaller. The
DeviceInstaller™ main dialog box is displayed (
Figure 3 ).