2 configuring the com port redirector, Configuring the com port redirector, Figure 23: installation complete window – Kramer Electronics VP-725N User Manual
Page 22
20
Installing and Configuring Com Port Redirector Software
Figure 23: Installation Complete Window
9. Click the Close button.
3.2
Configuring the Com Port Redirector
Note: Observe the following general guidelines when preparing the device server
for use with Com Port Redirector:
Do not run the Com Port Redirector with other software that installs a virtual
com port
Do not run the Com Port Redirector with other Com Port Redirection
software on the same PC
The device server to which Com Port Redirector will connect must have an
IP address
The PC running Com Port Redirector must have a good network connection
to the device server
Do not use com ports 1, 2, 3 or 4
If redirecting over a Wide Area Network (WAN), both the PC and the device
server must have a correct gateway address configured in their TCP/IP
settings