Kramer Electronics VP-730 - Manual (Page 15)

10 VP-730 - Connecting the VP-730
5 Connecting the VP-730
Always switch off the power to each device before connecting it to your
VP-730. After connecting your VP-730, connect its power and then
switch on the power to each device.
To connect the VP-730 as illustrated in the example in Figure 3 , do the following:
1. Connect the video sources:
 A component video source (for example, a DVD player) to the
UNIV. IN 1 RCA connectors, Y/CV, Pb/C and Pr
Component video is sometimes called YUV, or Y, B-Y, R-Y
 A composite source (for example, a DVD player) to the UNIV. IN 2
RCA connector
 A computer graphics source to the PC 1 IN 15-pin HD computer
graphics video connector
 An HDMI source (for example, a DVD player) to the HDMI 1 IN
connector
 A graphics data source (for example, JPEG files that should be smaller
than 1MB and should not exceed a resolution of 2048x1536, from a
PC or a USB flash drive) to the USB connector on the front panel of
the machine
2. Connect the balanced stereo audio sources, that is, the audio of:
 Component video source 1 to the AUDIO UNIV. IN 1 terminal block
 Composite video source to the AUDIO UNIV. IN 2 terminal block
 Computer graphics source to the AUDIO PC 1 terminal block
Although this connecting example shows only several inputs that are
connected, you can connect all the inputs simultaneously.
i
i