Kramer Electronics VP-730 - Manual (Page 16)

VP-730 - Connecting the VP-730 11
11
3. Connect the video outputs:
 The HDMI OUT connector to an HDMI acceptor (for example, a
plasma display)
 The PC OUT 1 15-pin HD computer graphics video connector to a video
acceptor (for example, an analog display 1)
In the HDTV mode, the signal goes out via three PINS: PIN 1 is Red or Pr, PIN 2
is Green or Y, PIN 3 is Blue or Pb
 The PC OUT 2 15-pin HD computer graphics video connector to a
video acceptor (for example, an analog display 2)
In the HDTV mode, the signal goes out via three PINS: PIN 1 is Red or Pr, PIN 2
is Green or Y, PIN 3 is Blue or Pb
4. Connect the AUDIO OUT 5-pin terminal block and/or the S/PDIF digital audio
output to audio acceptors.
5. Connect the SPKR OUT block connector to a pair of loudspeakers, by
connecting the left loudspeaker to the “L+” and the “L-” terminal block
connectors, and the right loudspeaker to the “R+” and the “R-” terminal block
connectors.
Do not Ground the loudspeakers.
6. Connect the power cord.
We recommend that you use only the power cord that is supplied with this machine
7. If required, connect a PC via RS-232, see Section 5.1
The USB connector, audio sources and acceptors, and power cord are
not shown in
Figure 3 .
i