Kramer Electronics VP-730 - Manual (Page 36)

VP-730 - Configuring the VP-730 via the OSD MENU Screens 31
31
Setting Function Default
HDMI Input
HDCP
Set to On or Off for each HDMI input
HDCP support can be enabled (On) or disabled (Off) for each of
the HDMI inputs, allowing the source to transmit a non-HDCP
signal if required (for example, when working with a Mac
computer)
7.7.1 The Slideshow Feature
The VP-730 lets you run a slideshow via the USB input and set the slideshow
speed via the slideshow feature.
To prepare a slideshow:
1. Load the slideshow JPEG images to a USB memory stick.
The slides will appear in alphabetical order.
The JPEG file should be smaller than 1MB and should not exceed a resolution of
2048x1536
2. Open the Setup menu and set the desired speed in the slideshow item and
then close the menu.
3. Connect the Memory stick to the USB connector on the front panel.
4. Select the USB INPUT button on the front panel.
The slideshow begins at the set speed.
You have to set the slideshow parameters before you run the slideshow
You can control the slide show by pressing the:
• FREEZE button to pause
• USB button to play and stop the slideshow
• (up arrow) button to go to the previous slide
• (down arrow) button to go to the next slide