Kramer Electronics VS-162AVRCA - Manual (Page 25)

Operating Your Audio-Video Matrix Switcher
21
21
7.2.1 Choosing the Audio-Follow-Video or Breakaway Mode
You can switch video/audio signals in one of 2 ways, either:
• BREAKAWAY, in which video and audio channels switch
independently; or
• AUDIO-FOLLOW-VIDEO (AFV) in which all operations relate to
both the video and the audio channels 1
7.2.1.1 Setting the Breakaway Mode
To set the BREAKAWAY mode, either:
• Press the VIDEO (for video control only) button
If the VIDEO button illuminates, all operations and the LCD MATRIX
and STATUS Displays relate to Video; or
• Press the AUDIO (for audio control only) button
If the AUDIO button illuminates, all operations and the LCD MATRIX
and STATUS Displays relate to Audio
7.2.1.2 Setting the Audio-Follow-Video Mode
To set the Audio-follow-video (AFV) mode 2
1. Press the AFV button.
:
2. If the audio and video configurations are the same, the AFV button
illuminates. All operations and the LCD MATRIX and STATUS Displays
relate to both the video and the audio channels.
3. If the audio configuration differs from the video configuration, each of the
following will occur simultaneously:
• The Audio and Video buttons will blink in a fast alternating cycle
• The TAKE LED will blink
• In the MATRIX Display, digits that represent different audio/video
configurations will blink alternately
(For example, the MATRIX Display would show as the input for output
10, the blinking, alternating digits 01 and 02, if IN 1 was routed to OUT
10 for video, and IN 2 was routed to OUT 10 for audio)
4. Press the TAKE button to confirm the modification (reconfiguring the
audio according to the video).
1 Audio and video connections are the same and switch at the same moment at the beginning of the sync
2 Be aware that all audio configurations that differ from the video configurations will be lost when returning to the audio
breakaway mode after the AFV mode. To store an audio configuration setup, see section 7.2.5