Kramer Electronics VS-162AVRCA - Manual (Page 30)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Operating Your Audio-Video Matrix Switcher
26
7.2.4 Clearing
1
You can clear (delete):
• One output (see section 7.2.4.1)
• Several outputs (see section 7.2.4.2)
• All outputs (see section 7.2.4.3)
7.2.4.1 Clearing an Output
To clear an output (in the AT ONCE mode):
1. Press the appropriate OUT button.
The MATRIX Display shows the 2 blinking digits, representing the
present input number for that specific output 2
out # x
. If the present input is clear,
the 2 blinking digits 00 appear in the MATRIX Display.
The STATUS Display shows the message:
Where x is the output number
2. Press the OFF button 3
out # x
reset
.
The input is cleared and the MATRIX Display does not show any Input #
in its place.
The STATUS Display momentarily shows the message:
Where x is the output number
To clear an output (in the CONFIRM mode (the TAKE LED is lit)):
1. Repeat step 1 above.
2. Press the OFF button
3 .
The MATRIX Display shows the 2 blinking digits 00 instead of the
previous 2 blinking digits and the TAKE LED blinks.
The STATUS Display shows 4
out # x
reset
the message:
Where x is the output number
1 “Clearing” means disconnecting the output from any of the inputs, and leaving it disconnected
2 For example, pressing OUT button 9 shows the blinking digits 01 if input 1 was previously routed to OUT 9
3 You can press the OFF button first, and then an OUT button (the order is irrelevant)
4 Continuously, within the limit of the timeout (approximately 30 seconds)