Kramer Electronics VS-162AVRCA - Manual (Page 46)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
MENU Commands Sequence
42
Figure 19: Machine Identification
8.11 Choosing the initial RESET
Choose to reset the machine 1
• Current status
to the:
2
• Factory default (resets to the pre-installed factory default state
(reloads the current setup)
3
Each VS-162AV unit ships in its factory default
)
To reset the machine, do the following:
1. Press the MENU button until you reach the initial RESET command.
The MATRIX Display shows the message:
initial RESET
yes -> TAKE, next -> MENU
2. Press the TAKE button.
The MATRIX Display shows the message:
Outkey 1: Current status
2: Factory default
3. Press the OUT button 2, for example, to reset to the factory default.
The TAKE LED blinks and the Displays show the messages:
Reset to factory default
Press TAKE to execute
WARNING
!!!!!
4. Press the TAKE button again.
The Displays show the messages:
Reset to factory default
confirm by pressing OUT # 7
WARNING !!!!!
5. Press the OUT # 7.
The machine resets to the factory default and the Displays show the first
messages of the reloading progress (as Figure 19 illustrates).
1 Without having to switch the power off and on
2 Sometimes called a “soft reset”
3 Each unit ships in its factory default state that is a 16x16 audio-video matrix, with all setups empty and each input
connected to its corresponding output (for example, 1-to-1)