Kramer Electronics VS-88FO - Manual (Page 21)

18 VS-88FO - Connecting the VS-88FO
6. Select Use the following IP Address for static IP addressing and fill in the
details as shown in Figure 9 .
For TCP/IPv4 you can use any IP address in the range 192.168.1.1 to
192.168.1.255 (excluding 192.168.1.39) that is provided by your IT
department.
Figure 9: Internet Protocol Properties Window
7. Click OK.
8. Click Close.
5.5.2 Connecting the Ethernet Port via a Network Hub or Switch
You can connect the Ethernet port of the VS-88FO to the Ethernet port on a
network hub or using a straight-through cable with RJ-45 connectors.
5.5.3 Control Configuration via the Ethernet Port
To control several units via Ethernet, connect the Master unit (Device 1) via the
Ethernet port to the Ethernet port of your PC. Use your PC provide initial
configuration of the settings (see Section 5.5 ).