Kramer Electronics VS-88FO - Manual (Page 32)

VS-88FO - Kramer Protocol 3000 29
9 Kramer Protocol 3000
The VS-88FO can be operated using serial commands from a PC, remote
controller, or touch screen. The unit communicates using the default Kramer
Protocol 3000 but can also use Kramer Protocol 2000.
This section describes:

How to switch between Protocol 3000 and Protocol 2000 (see Section 9.1 )

Kramer Protocol 3000 syntax (see Section 9.2 )

Kramer Protocol 3000 commands (see Section 9.3 )
9.1 Switching Protocols
Protocols can be switched either from the front panel buttons or by transmitting
protocol commands.
To switch protocols using the front panel buttons:

To choose Protocol 2000, press OUT 1 and OUT 2 at the same time

To choose the Protocol 3000, press OUT 1 and OUT 3 at the same time
To switch protocols using protocol commands:

To switch from Protocol 3000 to Protocol 2000, send the following command:
#P2000<CR>

To switch from Protocol 2000 to Protocol 3000, send the following command:
0x38, 0x80, 0x83, 0x81
Note: If you are using Kramer’s Windows ®
-based control software it operates only
with Protocol 2000. If the VS-88FO is set to Protocol 3000, it automatically
switches to Protocol 2000.
Download the latest software from our Web site at http://www.kramerelectronics.com.