Kramer Electronics VS-88FO - Manual (Page 24)

VS-88FO - Connecting the VS-88FO 21
5.7 Controlling Using the Ethernet Port
You can control the VS-88FO over the RS-232/RS-485 port or the Ethernet using
the Kramer K-Router application.
If you are controlling a standalone unit using RS-232 or the Ethernet, configure the
unit as master (MACH #1), see Section
5.2.1
.
5.8 Using the Ethernet Reset Button
To reset Ethernet parameters to the factory defaults:
1. Turn the power switch OFF then, while pressing the FACTORY RESET
button, turn the power switch ON.
2. The unit powers up and loads its memory with the factory default definitions.
3. The unit also erases all stored presets, returns to the default Protocol 3000
and indicates “F-rst” on the 7-segment display.