Kramer Electronics VS-88HD - Manual (Page 20)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the VS-88HD
16
6.6 Switching Genlocked Video Signals
The genlock feature lets you switch genlocked video signals according to
timing of the GENLOCK reference input
1
1. Connect the GENLOCK cable.
.
2. To set the genlock timing, press and hold for 3 seconds the appropriate input
button as follows
2
Table 5: Genlock Settings
:
To Set Press and Hold
for 3 Seconds
Displayed
1080i/p @50Hz IN 2 1080 50H
720p @60Hz IN 3 720P 60H
PAL @50Hz IN 4 PAL 50H
NTSC @60Hz IN 5 NtSC 60H
Note: When turning the machine ON, the last stored setup is shown in the
7-segment display.
6.7 Connecting the Ethernet Port
You can connect the VS-88HD via the ETHERNET in the following ways:
• For direct connection to the PC, use a crossover cable (see section
6.7.1 )
• For connection via a network hub or network router, use a
straight-through cable (see section 6.7.2 )
6.7.1 Connecting the ETHERNET Port Directly to a PC (Crossover
Cable)
You can connect the Ethernet port of the VS-88HD to the Ethernet port on
your PC, via a crossover cable with RJ-45 connectors.
This type of connection is recommended for identification of the factory default
IP address
3
After connecting the Ethernet port, configure your PC as follows:
of the VS-88HD during the initial configuration
1. Right-click the My Network Places icon on your desktop.
1 According to SMPTE RP-168. The sources must be genlocked to the GENLOCK input in order to switch cleanly
2 The unit will detect automatically when SD-SDI inputs are used
3 The default IP address is 192.168.1.39