Kramer Electronics VP-790 - Manual (Page 13)

Figure 2: VP-790 Genlock Presentation Switcher/Scaler Rear Panel
# Feature Function
17 SDI IN BNC Connector Connect to the SDI source
18 Y/C IN 4-pin Connector Connect to the s-Video source
19 CV 2 IN RCA Connector Connect to the composite video 2 source
20 CV 1 IN BNC Connector Connect to the composite video 1 source
21 GENLOCK IN BNC Connector Connect to an external genlock input
22 S/PDIF OUT RCA Connector Connect to a digital audio acceptor
23 HDMI Connector Connect to the HDMI source
24 PC IN 15-pin HD Connector Connect to the computer graphics source
25 DVI IN DVI-I Connector Connect to the DVI source
26 RGB/COMPONENT IN BNC
Connectors S
Connect to the RGBS/component video source
R/Pr
G/Y
B/Pb
27 DVI-D/HDMI OUT DVI Connector Connect to the DVI/HDMI acceptor
28 PC OUT 15-pin HD Connector Connect to a VGA acceptor
29 SDI OUT BNC Connector Connect to an SDI acceptor
30 PROG USB Connector Connect to a PC for firmware upgrade
31 ETHERNET Connector Connects to the PC or other Serial Controller through computer networking
32 RS-232 9-pin D-sub Port Connect to the PC or the remote controller
33 REMOTE IR Opening (Covered by a cap. The
3.5mm connector at the end of the internal IR
connection cable fits through this opening) Connects to an external IR receiver unit for controlling the machine via an IR
remote controller instead of using the front panel IR receiver (see
Section 3.1 )
34 Power Connector with Fuse AC connector, enabling power supply to the unit
35 POWER Switch Illuminated switch for turning the unit ON or OFF
8
VP
-7
9
0
–
Ov
e
rv
ie
w