Kramer Electronics VP-790 - Manual (Page 29)

24 VP-790 - Configuring the VP-790 via the OSD MENU Screens
6.6 The Geometry Screen
Figure 10: Geometry Screen
Setting Function Default
Application Select the output application: Off, Keystone, Anyplace, Rotation
or PC
Location Select the location of the display: Front Tabletop, Front Ceiling,
Rear Tabletop or Rear ceiling
Horizontal Keystone Adjust the horizontal keystone
If the projector is located at an angle to the left or right of the
screen
Vertical Keystone Adjust the vertical keystone.
If the projector is located at an angle above or below the screen
Diagonal Projection Move the location of each corner of the display separately
(horizontal and vertical): Top Left, Top Right, Bottom Left,
Bottom Right or Reset All (to reset diagonal projections settings)
When selecting a corner, for example the Top Left corner, the
following message appears:
Use the  keys to drag the top left corner of the screen.
Hit Enter to go back
Pincushion/Barrel Adjust the pincushion or barrel appearance of the screen: -20 to
20
Rotation Rotate the display by 180 degrees clockwise or
counterclockwise: -180 to 180
Discrete Warp Map Set to a preset warp configuration: Off, 1 to 8
Warp maps created with the “Warp Generator” PC application
can be uploaded into VP-790 and processed accordingly
Reset All Resets to default view