Kramer Electronics VP-790 - Manual (Page 27)

22 VP-790 - Configuring the VP-790 via the OSD MENU Screens
Figure 9: Audio Screen
Setting Function
Auto Zoom Select to automatically crop and zoom the input video image so it
outputs the appropriate part in the matrix
Units Wide Set the number of screens comprising the width of the wall display
matrix (1 to 4)
Units High Set the number of screens comprising the height of the wall display
matrix (1 to 4)
H-Position Define the horizontal position of the display in the matrix
The unit will cut and resize the output signal according to the display’s
location in the matrix
V-Position Define the vertical position of the display in the matrix
The unit will cut and resize the output signal according to the display’s
location in the matrix
Blend Width Set the overlap region for the left, right, top and bottom blend regions
In the overlap region, the image intensity gradually fades towards the
edge of the blend area (the fading curve can be controlled via the S-
Curve item below)
The blend width is set in output pixels with a range of up to a quarter of
the output resolution.
For a configuration with two projectors, for example, in the horizontal
direction, the overlap can be higher to allow 16:9 images to fit on two
combined projectors with an aspect ratio of 4:3 or 5:4
Set the blend width offset for the left, right, top and bottom blend regions
The area between the edge and the start of the blend area is black. The
total number of pixels of the blend area and the offset region is limited by
the same amount of pixels as for an offset of zero