Figure 11: typing the ip number – Kramer Electronics PL-50 User Manual
Page 17
Connecting the PL-50 Power Controller - Monitor
13
6.3 Controlling via the Embedded Web Pages
The embedded Web page can be used to remotely operate the PL-50 via the
).
6.3.1
Setting the Embedded Web Page
Before you use the embedded Web pages to control the PL-50 via the
Ethernet, check that the Java™ software is installed on your computer. If not,
download it from:
A description of each Web page appears if you hover with your mouse over the
question mark that appears on the left side of the screen.
To control the PL-50 via the embedded Web page, make sure that it is
connected to the Ethernet port of your computer and do the following:
1. Open your Internet browser.
2. Type the unit’s IP number
in the address bar of your browser (or the name, if
using DHCP):
Figure 11: Typing the IP Number
The following window appears:
Figure 12: Loading the Embedded Web Pages
1 The default IP number is 192.168.1.39, and may be changed by the system integrator