Kramer Electronics PL-50 - Manual (Page 25)

Connecting the PL-50 Power Controller - Monitor
21
6.3.6 The Power Measurement Screen
Figure 21 and Table 7 define the Power Measurement screen:
Figure 21: The Power Measurement Screen
Table 7: The Power Measurement Screen Features
Feature Function
Power Status Status indicator per channel:
Measured – if the standby and active values are available (Channel 4 in this
example)
Not Measured – if one or both of the values were not measured (for
example, Channel 1)
Power Measurement Click Standby or active to measure the standby and/or Active values for an
outlet connected to a channel (once measured, the status changes from
“Not Measured” to “Measured”)
Click clear to clear the Standby and Active data for that channel 1
HELP BOX
This page lets you start the "Standby" and "Active" mode measurement
process. You can also clear the current "Standby" and "Active" thresholds.
1 You can also reset the data for all the channels by pressing the reset button located on the rear panel of the machine (see
Figure 2 and Figure 3 ) and plugging the power ON while pressing