Kramer Electronics SP-12HD - Manual (Page 11)

Connecting the SP-12HD HD-SDI Processor
9
9
6 Connecting the SP-12HD HD-SDI Processor
You can use your SP-12HD to convert
1
composite video, s-Video,
component video (YUV), or SDI signals to composite video (PAL or
NTSC), s-Video, component video (YUV) and
2
Figure 2
SDI, as well as to a
“Before/after” split-screen, as the example illustrates in .
To connect
3
the SP-12HD Digital Video Processor, do the following
4
1. Connect the following sources to the SP-12HD:
:
• The composite video source (for example, a DVD player)
to the CV INPUT BNC connector
• The s-Video source (for example, an S-VHS player) to the
Y/C INPUT 4-pin connector
• The SDI source (for example, a digital video player) to the
SDI INPUT BNC connector
2. Connect the component video INPUTS BNC connectors, Y, B-Y, and
R-Y to YUV video source.
3. Connect the following acceptors to the SP-12HD:
• The SPLITTER OUTPUT BNC connector to the split
image acceptor (for example, a display)
• The Y/C OUTPUT 4-pin connector to an s-Video acceptor
(for example, a display)
• The CV OUTPUT BNC connector to a composite video
acceptor (for example, a display)
• The BNC OUTPUTS connectors: Y, B-Y and R-Y to a
video acceptor (for example, a plasma display)
• The two SDI OUTPUTS BNC connectors to two serial
digital video acceptors (for example, two monitors: SDI 1
and SDI 2)
4. Connect a PC or other controller, if required (see section 6.1 ).
5. Set the DIP-switches (see section 6.2 ).
6. Connect the AC power cord.
1 The SP-12HD does not perform standard conversion or scaling. The output resolution is always identical to the input
resolution
2 All output formats are always available when the format is valid for the input resolution being used
3 When only one output is required, connect that output of the SP-12HD, and leave the other outputs unconnected
4 Switch OFF the power on each device before connecting it to your SP-12HD. After connecting your SP-12HD, switch on
its power and then switch on the power on each device