Kramer Electronics SP-12HD - Manual (Page 13)

Connecting the SP-12HD HD-SDI Processor
11
11
6.1 Connecting the RS-232 Port
Figure 3: Connecting the RS-232 Port
6.2 Setting the DIP-Switches
Configure the SP-12HD unit by setting the 8 DIP-switches, as defined in
Table 2 and Table 3 :
Table 2: DIP-Switch Settings
DIP-Switch Set as follows:
1 PEDESTAL ON for pedestal of output signal (7.5 IRE offset selection for
NTSC); OFF for no pedestal
2 Input sync bi-level or tri-level
(HDTV)
Active only in HDTV mode: ON for bi-level input sync, OFF for
tri-level.
3 Output sync bi-level or tri-level
(HDTV)
Active only in HDTV mode: ON for bi-level output sync, OFF for
tri-level.
4 TEST - 4 These three switches define test signals (see Table 3 )
5 TEST - 5
6 TEST - 6
7 AGC ON to enable Auto Gain Control ; OFF to disable
8 ADDR Defines address of machine: OFF – 0x18; ON – 0x19