Kramer Electronics SP-12HD - Manual (Page 9)

Your SP-12HD HD-SDI Processor
7
7
# Feature Function
19 V/RED Button Press the V
1
/RED
2
20
button and adjust using the + and – buttons,
when COLOR SPACE button is activated
COLOR SPACE Button Press to select the color space of color control; if the COLOR
SPACE button doesn’t illuminate, color control is disabled in any
color space
21 YUV/RGB LEDs Cycle between different color spaces of color control: YUV and
RGB. The corresponding LED lights
22 STORE Button Stores the current setup in the non-volatile memory
3
23 RECALL Button Recalls a setup from the non-volatile memory
3
24 7-segment Display Displays data when using a front panel button
25 - Button Press to decrease the level
26 + Button Press to increase the level
27 PANEL LOCK Button Disengages/engages the front panel buttons (press and hold
down for 2 seconds to toggle)
28
INP
UT
S
Y/C 4-pin Connector Connects to the s-Video source
29 Y BNC Connector Connects to the Y component of the YUV source
30 CV BNC Connector Connects to the composite video source
31 V(R-Y) BNC Connector Connects to the V component of the YUV source
32 U(B-Y) BNC Connector Connects to the U component of the YUV source
33 HD-SDI BNC Connector Connects to the HD-SDI source
34
O
U
T
P
U
T
S
SPLITTER Y BNC Connector Connects to the split image Y component of the YUV acceptor
35 SPLITTER CV BNC Connector Connects to the split image CV acceptor
36 SPLITTER V BNC Connector Connects to the split image V component of the YUV acceptor
37 SPLITTER U BNC Connector Connects to the split image U component of the YUV acceptor
38 HD/SDI BNC Connector Connects to the serial digital video acceptor 1
39 HD/SDI BNC Connector Connects to the serial digital video acceptor 2
40 YC 4-pin Connector Connects to the s-Video (Y/C) acceptor
41 Y BNC Connector Connects to the Y input of the YUV acceptor
42 CV BNC Connector Connects to the composite video acceptor
43 U(B-Y) BNC Connector Connects to the U input of the YUV acceptor
44 V(R-Y) BNC Connector Connects to the V input of the YUV acceptor
45 RS-232 Port Connects to the PC or the remote controller
46 SETUP DIP-switches Use to configure and test the unit (see section 6.2 )
47 Power Connector with Fuse AC connector enabling power supply to the unit
48 Power Switch Illuminated switch for turning the unit ON or OFF
1 For YUV
2 For RGB
3 See section 7.1