RADWAG BALANCES 3Y SERIES - Manual (Page 97)

- 97 -
Use of data contained in the header and footer.
Should data from header and/or footer be used, follow below procedure:
o
Press < Print header> soft key before starting density determination
procedure,
o
Carry out density determination procedure
 A report is printed automatically on completing the second
measurement (Weighing 2),
 When density determination result is displayed, it is possible to print
it for numerous times by multiple pressing of < PRINT > key,
o
Press < Print footer > soft key after completing the density
determination procedure.
Caution :
Remember to select data to be printer in the header, footer and report. For
details see section “PRINTOUTS”.
21. ANIMAL WEIGHING
Working mode< Animal weighing> enables reliable determining mass of
objects in motion. In principle, this type of objects generate unstable
measurement, thus it requires using a different filtering method of
measurement signal.
Working mode activating procedure
•
while in the main window, press soft key located in the upper bar of the
display, which opens a submenu <Working modes> with selection of
available working modes,
•
select < Animal weighing> mode, the software automatically returns to
the main window and displays pictogram in the upper bar,
The grey coloured workspace contains the following data:
o
Averaging time 5
o
Threshold 10