Advanced Technology International USA M200 - Manual (Page 11)

Copyright © 2005 Advanced Technologies Inc. All rights reserved. V205.
• Card revaluation can be turned off
• Card vend price can be different than cash vend price
• Time delay reset (TDR) ensures full copy imaging on last full copy credit
• Anti-cheating timeout delay monitors for late copy counts after change return
request made
• Readouts show current (resettable) and cumulative (nonresettable) vend and
bypass copies totals by copy type (A through F)
Technical Specifications
• Controller uses safe low voltage (24 VAC)
• Controller totally isolated from copier / printer
• Controller works on most all copiers and with most copier signals
• Fully compatible with Ricoh Aficio, Xerox and Minolta color copiers
• Canadian coin acceptance switch selectable with high capacity changer
• Two key coin inventory system adds measure of security
• Dimensions: 25.5" x 16" x 5.5"
• Weight: 46 lb
Warranty
The M7506 is warrantied against manufacturing defects for a period of two years
from date of shipment, to be determined by the serial number on its main board's
microchip. Warranties for components of the M7506, if different, supercede this
general warranty.
Specifically, the MDB changer is warrantied against manufacturing defects for a
period of three years from date of manufacture, to be determined from the first
four digits of its serial number (wwyy).
The bill validator is warrantied against manufacturing defects for a period of two
years from date of manufacture, to be determined from the first four digits of its
serial number (wwyy).
Note that the card reader is warrantied against manufacturing defects for a period
of one year from date of shipment, to be determined by the serial number on the
card reader itself.
Advanced Technologies (TekVend) agrees to repair or replace at its discretion any
of the above items within the warranty periods specified for them. Advanced
Technologies (TekVend) agrees to pay ground return shipping and insurance on all
warranty repair or replacements.
Advanced Technologies (TekVend) cannot be responsible for any damage that
occurs to product returned to it due to inadequate return shipment procedures.
The shipper is responsible for ensuring that return shipment packaging is
adequate and that the return shipment is adequately insured.
Advanced Technologies (TekVend) does not warranty its product for damage
caused by abusive use, vandalism, improper installation, and improper field
repair. Installer is expected to use the original copier specific harness (sprig)
supplied by Advanced Technologies (TekVend), and install the M7506 on the
originally specified copier, unless otherwise authorized.