Advanced Technology International USA M200 - Manual (Page 19)

Copyright © 2005 Advanced Technologies Inc. All rights reserved. V205.
Advanced Technologies, Inc.
3758 West Devon Avenue | Lincolnwood, IL 60712 | USA
Sales: +1-800-815-6908 | Service: +1-847-329-9875 | Fax: +1-847-410-0094
Email: [email protected] | Web: http://www.tekvend.com
TC11N Copier / Printer Controller
Product Overview
The TC11N Copier / Printer Controller is a proprietary magnetic card reader /
encoder that vends images against value stored on reusable or throwaway magnetic
stripe cards.
A special Administrator card is used to initialize and value these cards, and to set
control parameters and prices. Depending on copier / printer make and model, and
copier control mode selected, individual prices for up to four different image types
are supported.
Copier / printer use privileges are determined by group numbers stored both on the
cards and in the TC11N.
Usage statistics can be read out on the TC11N's LCD display.
The TC11N comes standard with its own 24 VDC power supply, but it can run off
power from the copier / printer in many cases. It is shipped with a copier / printer
specific sprig at no extra charge.
The TC11N has a small footprint, measuring only 4" x 3.5" x 7", and weighs a mere 2
lb. It comes with a one year (from date of shipment) warranty for manufacturing
defects.
Warranty
The M7500 is warrantied against manufacturing defects for a period of one year from
date of shipment, to be determined by the serial number at boot up [equal to the
serial number on its back].
Advanced Technologies (TekVend) agrees to repair or replace at its discretion any
TC11N within the warranty period. Advanced Technologies (TekVend) agrees to pay
ground return shipping and insurance on any warranty repair or replacement.
Advanced Technologies (TekVend) cannot be responsible for any damage that occurs
to product returned to it due to inadequate return shipment procedures. The shipper
is responsible for ensuring that return shipment packaging is adequate and that the
return shipment is adequately insured.
Advanced Technologies (TekVend) does not warranty its product for damage caused
by abusive use, vandalism, improper installation, and improper field repair. The
installer is expected to use the original copier specific harness (sprig) supplied by
Advanced Technologies (TekVend), and install the TC11N on the originally specified
copier, unless otherwise authorized.