Actiontec electronic Actiontec Wireless DSL Gateway GT704WG - Manual (Page 15)

10
Actiontec 54 Mbps Wireless DSL Gateway User Manual
11
Chapter 2 Performing a Quick Setup
5b. If PPP o E was selected in step 5, select the IP type (“Dynamic IP-DHCP
[Default]” or “Single Static IP Address”). If Single Static IP Address was select-
ed, enter the address in the appropriate text box.
6. Optional - Select the DNS type (“Dynamic DNS Addresses [Default]” or
“Static DNS Addresses”). If Static DNS Addresses was selected, enter the pri-
mary and secondary DNS addresses in the appropriate text boxes. If unsure
what to enter in this section, contact the ISP .
7. Click Apply at the bottom of the screen.
8. Read the instructions on the next screen. The Gateway is successfully
configured.
The Power light flashes rapidly while the Gateway restarts, then glows steadily
green when fully operational. The Internet light will also glow steadily green. The
Gateway is now configured and users can start surfing the Internet.
If an error appears, stating the Web browser was unable to connect to the Internet,
check the configuration settings. Ensure all the information required by the
ISP is
entered correctly.