Actiontec electronic Actiontec Wireless DSL Gateway GT704WG - Manual (Page 43)

38
Actiontec 54 Mbps Wireless DSL Gateway User Manual
39
Chapter 5 Configuring Advanced Settings
5. Select Dialout on-demand (optional).
To have the Gateway automatically connect to the Internet whenever needed
(when a Web browser is opened, for example), activate “Dialout on-demand”
by clicking in the appropriate check box. When Dialout on-demand is acti-
vated, the user can also set the Gateway to disconnect from the Internet after a
certain amount of idle time (no Internet activity). To do this, enter the num-
ber of idle time minutes (minimum 2 minutes) before disconnection occurs
in the text box before “Minutes.”
6. Adjust MTU settings (optional).
Enter the maximum transmission unit ( MTU ) value (in bytes) in this text
box. This value corresponds to the largest physical packet size the network is
allowed to transmit. Packets larger than this size are divided into smaller pack-
ets. It is recommended to leave this value set at the default (1492).
When finished in this screen, click Apply to activate any changes made.
QoS Settings Upstream
Selecting QoS Settings Upstream from the “Advanced Setup” screen causes the
“QoS Upstream Settings” screen to appear.