Autodesk XW8400 - Manual (Page 12)

Introduction 1
6
For workflow information related to the HP xw8400 running on Linux for Incinerator, refer to
the Autodesk Incinerator 2009 Installation and User Guide.
To install Lustre on an HP xw8400 workstation:
1. Review the guidelines for working with hardware components. See “Hardware
Configuration Guidelines” on page 7.
2. Connect all peripherals (mouse, keyboard, graphics monitor, storage, etc.) to each
workstation in your workgroup, and connect each workstation to the network. See
Chapter
2, “Connecting Peripherals,” on page 15.
3. Connect your workstation to Autodesk Stone® Direct storage. See the Stone Direct
Configuration Guide.
4. Connect your Master or HD Station to a Slave Renderer, a control surface, tablet, and video
I/O components. See
Chapter 3, “Connecting System Components,” on page 27.
N OTE : The Slave Renderer is not used in Incinerator configurations.
5. Perform the procedures in the Autodesk Lustre 2009 Software Installation Guide or the
Autodesk Incinerator 2009 Installation and User Guide to install and license Lustre and
Incinerator.
Related Documentation
The following table describes the documentation associated with your application. For a
detailed list of the latest documentation, see your release notes.
User Guides Provides
Autodesk Lustre 2009 User Guide Detailed instructions on using the software.
Autodesk Control Surface User Guide Detailed instructions on using the Autodesk
control surface and the Tangent CP100.
Autodesk Lustre 2009 New Features Guide A list of the new features for this release.
Autodesk Lustre 2009 Hot Keys Card A list of the most frequently used hot keys.
Autodesk Lustre 2009 Release Notes A complete list of documentation and information
on late-breaking features.
Autodesk Lustre 2009 Fixed and Known
Bug List A complete list of fixed and known bugs for this
release.