Konica Minolta bizhub PRESS C8000e User Manual

Page 308

Advertising
background image

bizhub PRESS C8000

9-13

9.5

Troubleshooting Tips

9

If remedies mentioned above do not work, contact your service representative.

Fi

nis

her FS-612

Finisher does not
operate.

Is any mishandled paper left inside
the finisher?

Check for paper misfeed and re-
move it, as required.

Is finisher front door slightly open?

Securely close the finisher front
door.

Staples are incor-
rectly positioned
(rotated by 90 de-
grees) in copies.

Is Image Rotation activated?

Reload copy paper in appropriate
direction.

Printed sheets
skew in the output
sets and cannot be
stapled or punched
in position.

Is paper excessively curled?

Reload the paper upside down into
the tray.

Are the side guides of the selected
tray (or paper guides of PI tray)
aligned to paper?

Make sure the side guides (or pa-
per guides) are securely aligned to
paper in the tray to be used.

Using Punch
mode, printed
sheets cannot be
punched.

Does the Punch-Hole Scraps Box
indicator light on the Machine
Screen?

Empty the scrap box of the punch
kit.

Printed sheets can-
not be stapled in
position.

Is paper excessively curled?

Reload the paper upside down into
the tray.

Auth

enticat

ion

Uni

t (IC Card

Typ

e

)

AU-20

1

The status indica-
tor LED does not
light in green even
after the USB cable
of Authentication
Unit (IC Card
Type) AU-201 is
connected to the
USB port of the
main body.

A possible cause can be malfunc-
tion of the USB port of the main
body.

Turn OFF the main power switch
of the main body, then disconnect
the USB cable of Authentication
Unit (IC Card Type) AU-201 from
the USB port of the main body. Re-
connect it, then wait 10 seconds or
longer before turning the main
power switch ON again.

IC

C

a

rd

IC cards cannot be
authenticated.

Is Authentication Unit (IC Card
Type) AU-201 connected to the
USB port of the main body?

Securely connect the USB cable of
Authentication Unit (IC Card
Type) AU-201 to the USB port of
the main body.

Is the machine set to use the USB
port?

Contact your administrator.

Case

Checkpoint

Remedy

Advertising