Konica Minolta KIP 7100 - Manual (Page 144)

KIP Touchscreen Software
Note: *Feature Not Applicable to KIP Network Printers Only.
This information is solely for use of KIP Personnel and KIP Authorized Dealers. No part of this publication may be copied,
reproduced or distributed in any form without express written permission from KIP.  2012 KIP. vii_iv
- 143 -
Margins
Margins may be applied to all four sides equally or with
specific sizes.
Paneling Tab
Paneling will allow the user to create output
that would be too big for the printer to print
under normal conditions. For example if the
desired output is to be 108”x72” wide this can
be achieved by using paneling.
In this example we have a 36”x24” original that will
be paneled to 108”x72”. The paneling tab will look
like this. The user can set the count given to specific
values or let the software calculate the necessary
panels. The height can also be controlled to make
handling of the panels easier.
Gluing marks and an overlap can also be applied to assist with lining up the panels for assembly.