Konica Minolta KIP 7100 - Manual (Page 176)

KIP Touchscreen Software
Note: *Feature Not Applicable to KIP Network Printers Only.
This information is solely for use of KIP Personnel and KIP Authorized Dealers. No part of this publication may be copied,
reproduced or distributed in any form without express written permission from KIP.  2012 KIP. vii_iv
- 175 -
If no media installed then all bars would be empty
e. Type: Shows the media type ( set by User )
Example: Roll 1 is Bond
Roll 4 is Vellum
f. Width: Shows the set width ( set by User )
Example: Roll 1 is 30”
Roll 2 is 36”
Roll 3 is 24”
Roll 4 is 11”
Change Media Information
At the top of the Job List Screen is the region that displays the current media loaded in KIP 3000. Please
note that only rolls the printer has will be displayed.
a. Press the “Roll Info Menu” to set media type and width in all roll decks
g. Select the correct media width and type for each deck as required ( two roll model screen
shown below )
h. Select OK to set
i. The new settings will be noted
on the top of the Job Info
Screen