Konica Minolta KIP 7100 - Manual (Page 182)

KIP Touchscreen Software
Note: *Feature Not Applicable to KIP Network Printers Only.
This information is solely for use of KIP Personnel and KIP Authorized Dealers. No part of this publication may be copied,
reproduced or distributed in any form without express written permission from KIP.  2012 KIP. vii_iv
- 181 -
Total Run
This meter counts the total number of linear meters run on the printer in all countries. One count = one
linear meter
Custom Meter
This counter can be reset at any time to count the units in a particular job. The date of last “reset” is also
displayed. This counter’s units are the same as Meter A. Press the reset button to start at “0”
NOTE
The units of this counter are taken from the internal processor of the printer and can be “reset” if
care is not taken upon replacement of the DC Controller. Please see KIP 3000 Service Manual for
details on the setting procedures.
In case of discrepancies: The hard counter shall be taken as the correct value!
NOTE
If this counter differs from the hard counter on the printer contact your local service company!
The units of this counter are taken from the internal processor of the printer and can be “reset” if
care is not taken upon replacement of the DC Controller. Please see KIP 3000 Service Manual for
details on the setting procedures.
In case of discrepancies: The hard counter shall be taken as the correct value!