Konica Minolta KIP 7100 - Manual (Page 183)

KIP Touchscreen Software
Note: *Feature Not Applicable to KIP Network Printers Only.
This information is solely for use of KIP Personnel and KIP Authorized Dealers. No part of this publication may be copied,
reproduced or distributed in any form without express written permission from KIP.  2012 KIP. vii_iv
- 182 -
Scan Count
The Scan Count displays the total count of the “imaged” area. If the original was larger than the saved
imaged area only the saved imaged area is recorded. If the incorrect original size was selected the
selected size will be recorded.
Example:
With a 24x36 original
a. If the original was feed 36” wide with a 36” wide setting on the User Interface then 6 sq ft
recorded.
j. If the 36” wide original was scanned in at a 24” wide manual setting, the size will be recorded as
24x24 or 2 square feet.
Scan Count- Temp
This counter can be reset at any time to count the units in a particular job if so required. The date of last
“reset” is also displayed. This counter’s units are the same as in Scan Count. Press the reset button to
start at “0”
Software version
Displays the software KIP Touchscreen version for technical support
Firmware Version
Displays the printer firmware version for technical support
Printer EPROM
Displays the current EPROM version installed in the KIP Printer.
IPS Number
Displays the current IPS number, this is required for any optional upgrades to the KIP.