Konica Minolta KIP 7100 - Manual (Page 194)

KIP Touchscreen Software
Note: *Feature Not Applicable to KIP Network Printers Only.
This information is solely for use of KIP Personnel and KIP Authorized Dealers. No part of this publication may be copied,
reproduced or distributed in any form without express written permission from KIP.  2012 KIP. vii_iv
- 193 -
7100 Stacking
For use with the 7100 only. This allows the user to decide how the prints will
come out of the LIP 7100 Printer. There are three (3) methods for printing:
Front Only – All prints will stack on the front (top) of the printer
Back Only – All prints will stack out the back of the printer (optional stacker
needed).
Front & Back (default Front) – Prints can be printed to the front or back (optional stacker needed) Front
will be default.
Front & Back (default Back) - Prints can be printed to the front or back (optional stacker needed) Back
will be default.
Media QC Print
Automatic Initial Cut known as “Dummy Print”
is now added to the User Mode in Setting
Mode 2 of the printer. This is not a feature set
within the KIP. The service technician can set
this mode after unlocking the key operation
of the Sub UI (LCD Display/ OP Panel). Under
a certain usage environment, the first print of a job sometimes would have a wrinkle or an image void if
the prints are made with a roll media left in the deck for a long period. “Dummy Print” makes an
automatic 24” initial cut before processing a job to obtain optimum image quality and feed balance in
such conditions.
Master Lead / Trail Adjustment
The leading and trailing edges on scans and copies can be
adjusted to best suit user requirements. This adjustment adds or
removes image / media from all scans and copies and should
be considered a default setting of such.