Konica Minolta KIP 7100 - Manual (Page 202)

KIP Touchscreen Software
Note: *Feature Not Applicable to KIP Network Printers Only.
This information is solely for use of KIP Personnel and KIP Authorized Dealers. No part of this publication may be copied,
reproduced or distributed in any form without express written permission from KIP.  2012 KIP. vii_iv
- 201 -
Configuration 2, Page 3
Reboot IPS
This button will restart the KIP when the system is not responding / printing correctly.
Current Time
Set the current time using the arrow buttons. Please note that the Time Zone may need to be set. Please
contact your Local KIP Dealer to set the correct Time Zone.
Monochrome Quality Settings
If the Quality setting have been changed and the default settings are
needed, clicking on “Restore to Default” will set the quality Settings
back to Default.
Test pattern
A variety of test patterns may be printed from the KIP 3000 operator panel on an on-
demand basis. The following four predefined test patterns are available to assist in
pen table selection and overall quality verification.
36” x 60” tif – Used to test long printing and calibrate scan/copy operations
17” x 11” plt – Used to calibrate lead/trail edge settings
36” x 24” plt – Used to calibrate lead/trail edge settings
36” x 24” hprtl – Used to test output of mixed raster and vector data