Konica Minolta KIP 7100 - Manual (Page 23)

KIP Touchscreen Software
Note: *Feature Not Applicable to KIP Network Printers Only.
This information is solely for use of KIP Personnel and KIP Authorized Dealers. No part of this publication may be copied,
reproduced or distributed in any form without express written permission from KIP.  2012 KIP. vii_iv
- 22 -
Original
This region allows the setting of the Size Mode (Engineering or Architectural) & the original image type.
Original Size Mode
These buttons are used to select the Size Mode of Engineering or
Architectural.
This will allow the automatic width detection system to determine the image width when an original is
placed in the KIP 3000.
Engineering widths = 34, 22, 17, 11, and 8.5 inches
Architectural widths = 36, 30, 24, 18, 12, and 9 inches
Original Type
Select one of the four different predetermined original types. The selections are:
Line- used for simple line documents
Line / Photo- used for a combination of lines & photos
documents
Grayscale- used for a combination of lines & areas of shade
(CAD) originals
Photo- used for photographic originals