Konica Minolta KIP 7100 - Manual (Page 40)

KIP Touchscreen Software
Note: *Feature Not Applicable to KIP Network Printers Only.
This information is solely for use of KIP Personnel and KIP Authorized Dealers. No part of this publication may be copied,
reproduced or distributed in any form without express written permission from KIP.  2012 KIP. vii_iv
- 39 -
Copying to Multiple Cutsheets
a. Follow steps above (2.6.4)
b. After a short period of time the Printer will beep notifying the user to insert the cutsheet into the
Cutsheet feeder, the Job Info button will also be flashing.
c. Once the cutsheet has been printed there will be a short pause and the printer will start to beep
again. Insert the next cutsheet into the printer
d. Continue for multiples.
Note:
Only one cutsheet may be fed at a time and will time out after 3 minutes if no paper is inserted.
Note:
DO NOT insert the cut sheet media into the feeder while printing from a roll deck, as this may cause the
printer to jam.
Media Remaining
The installed roll information is displayed in the button of the particular roll deck. Beside each deck is a
volume of media that currently is left on the roll of media.
Indicators will display full, ¾, ½, ¼ or empty.