Konica Minolta magicolor 1690MF - Manual (Page 150)

Scanning With the Machine 6-17
2
Press the + or , key to select LDAP SEARCH , and then press the
Select key.
3
Press the + or , key to select NAME or E-MAIL , and then press the
Select key.
"
To search registered names, select NAME . To search e-mail
addresses, select E-MAIL .
4
Use the keypad to type in the search keyword (maximum of 10 charac-
ters), and then press the Select key.
The search begins, and the search results appear after a while. If no data
matches the search keyword,
NOT FOUND appears for about two sec-
onds.
"
For details on entering/editing text, refer to “Entering Text” on
page A-6.
"
Text starting with the first character of the maximum 10 characters
is searched for. Text will not be found if the search keyword is in
the middle of a word.
5
Press the + or , key to select the desired data, and then press the Select
key.
"
To check the found information, press the ) key.
"
An e-mail address exceeding 64 characters cannot be specified. If
such an e-mail address is specified,
ADDRESS IS TOO LONG
appears for about two seconds, and then the screen for specifying
the destination address appears.
"
To narrow down the search results, press the Back key, and then
perform step 4 again.
6
Press the Select key again.
7
Press the + or , key to select FINISH , and then press the Select key.
"
To add an additional e-mail address, select ADD in step 7, and
then specify the destination.
To edit the specified e-mail address, select
CHECK / EDIT in step
7, and then continue with step 2 of “Editing a Specified Destination
Address”.
To delete a specified e-mail address, select
CHECK / EDIT in step
7, and then continue with step 2 of “Deleting a Specified Destina-
tion Address”. The address cannot be edited.