Konica Minolta magicolor 1690MF - Manual (Page 180)

Replacing Consumables 7-17
Replacing the Fuser Unit
For optimum print quality and performance, use only approved KONICA
MINOLTA fuser unit for your specific machine type.
1
Turn off the machine and discon-
nect the power cord.
Note
There are extremely hot parts within the machine. Before replacing
the fuser unit, wait about 20 minutes after turning off the machine,
and then check that the fusing section has reached room
temperature, otherwise, you may get burnt.
2
Open the scanner unit.
"
If there is paper in the
output tray, remove it,
and then fold up the out-
put tray before opening
the scanner unit.