Konica Minolta magicolor 1650EN - Manual (Page 272)

Configuring the Printer (Administrator Mode) 7-87
"
If the range of permitted IP addresses in Access Permission Address
overlaps the range of refused IP address in Access Refuse Address,
the refuse setting of Access Refuse Address is given priority.
Accept Filter Enable
Accept
Filter
If Enable is selected, the enable accept filter to
the printer can be specified.
A maximum of five ranges of permitted IP
addresses can be specified. In addition, access
from an IP address out of the specified range is
prohibited.
If Disable is selected, the permitted access set-
ting is disabled.
Default: [Not checked]
Configuration Menu Equivalent:
MAIN MENU - INTERFACE MENU
- ETHERNET - IP SERVICES -
DISABLE FILTERS
Range 1 to
5 Specify the range of IP addresses permitted
access to the printer. Type the IP address at the
beginning of the range into the box on the left,
and the IP address at the end of the range into
the box on the right.
Range: 0-255 for each xxx triplet
Default: 0.0.0.0
"
To specify a single IP address, type the
same IP address into both the box for the
starting IP address and for the ending IP
address, or type “0.0.0.0” into the box for
either the starting IP address or the ending
IP address.
"
If the starting IP address is larger than the
ending IP address, the setting is not
applied.
Reject Filter Enable
Reject
Filter
If Enable is selected, the enable reject filter to the
printer can be specified.
A maximum of five ranges of refused IP
addresses can be specified.
If Disable is selected, the refused access setting
is disabled.
Default: [Not checked]